Mitsubishi Electric HD-6000 Owner's Manual page 59

Using the GUIDE Button to Display Channe View
TM
and Menus
GUIDE and Devices (1394 or mR
Controlled)
For NetCommand compafibie satellite receivers and
some cable boxes, GUIDE wiii display the on-screen
programming guide for the receiver or cable box. Press
ADJUST 4, _', • or • and ENTER to navigate the
displayed Guide. For NetCommand compatible satellite
receivers, you may also be able to use the number or
other additional buttons.
For NetCommand compatible DVD players, GUIDE wiii
display the DVD disc "top" menu (not the setup menu).
For AiV Discs, pressing GUIDE wiii display the Track List
screen. For IEEE 1394 devices with digital connections,
press GUIDE twice to display the device's Guide.
GUIDE and the Device SeJection Menu
For compatible traditional VCRs, pressing GUIDE when
the VCR is highlighted on the Device Selection menu
wiii change the VCR's inpuL
When the AiV Receiver icon is highlighted in the Audio
Section, pressing GUIDE switches the AiV Receiver
from analog audio to digital audio and vice versa.
GUIDE and the Record To Menu
When in the Record To menu, pressing GUIDE wiii
display the current list of programmed recordings.
Please see Record List, page 61 for more infomation.
GUIDE and ChanneJView
Figures 11 and !2
Press GUIDE while viewing Ant-1 or Ant-2 to display
a list of available memorized digital channels (D) and
analog (A) channel information (if available from the
broadcaster). This list is called ChannelViewTM.
ChannelView for digital channels wiii show the major
and sub-channels (or bitstreams). Analog channel
information wiii display as sent. Press ADJUST • or •
to scan through the all the channels in memory one by
one. To cycle through the choices quickly, press CH
•or•.
For detailed program information, press ADJUST I_,
to return to basic information press ADJUST 4. This
information is sent by the broadcaster. If limited data
is shown or no program data appears, it is because the
broadcaster is not sending the information. This is not
a defect of your HDTV receiver/contro//er.
Recording a Current Program
To record a current program, press REC (record) when
your program choice is highlighted on the program
list in ChannelView. A red "R" will be added after the
input name. The HD receiver/controller will immediately
switch to the selected channel and start recording.
Figure 11.ChannetView screen, current programs
Recording Future Programs
To record a future program, press ADJUST • or •
to select the channel you want to record from. For
detailed program information, press ADJUST I_',to
return to basic information press ADJUST 4. Press
REC (record) when your choice is highlighted. A red
"R" will be added after the input name. The message,
The recording has been added to the Record List will
display. To view, change or cancel a recording, use
the Record List (page 61). if a program title was not
sent by the broadcaster, you will be unable to set up a
recording and a message will display.
Figure !2. ChannelYiew screen, future programs
IMPORTANT
For complete ChannelView information to be
daily, the HDTV receiver/controller
powered Off between 5 to 15 minutes
depending on the number of channels in
memory, ff the HDTV receiver/controller loses
power, the program listings will be temporarily
most.
59