Mitsubishi Electric HD-6000 Owner's Manual page 79

V Chip Lock Menu, continued
Using VoChip with Program Ratings
Figure 22
You can choose the program ratings that you want
to allow during specific times of the day by using the
ADJUST buttons to higHight V-Chip from the V-Chip
Lock menu and press ENTER. When you seHect V-
Chip the screen in Figure 22 will dispHay.
Press ADJUST A or • to seHect On or Off. If you
seHected On then press ADJUST • to move to the TV
Rating box. Press ADJUST • or • to seHect the TV
Rating HeveH you want to allow. Press ADJUST • to
move to the TV Content Categories and press ADJUST
• or • to seHect. Press ENTER to add a check mark
to the TV Content Categories you want to bHock.
Press ADJUST • to move to the Programs Not rated
box and press ADJUST • or • to seHect a program.
Press ENTER to add a check mark to programs that
are not aHowed.
NOTE: If you select to block programs that carry the V-
Chip rating Programs Not rated, you may block News
or Emergency Bulletins, when "None" or "NR" Not
Rated V-Chip rating is included. Care should be used
when blocking programming that is not rated.
Press ADJUST • to move to the Movie Rating box.
Press ADJUST • or • to select the Movie Rating
level you want to allow. See the next page for detailed
information on rating guidelines.
To set the times when these guidelines will be active,
press ADJUST • or • to slowly select the time,
starting with the hours. Press and hold ADJUST •
or • to quickly select the hours, press ADJUST • to
select the minutes.
By setting the V-Chip Start Time and V-Chip Stop
Time to the same time, the V-Chip will be active 24
hours a day.
Figure 22. V-Chip Menu
Using the Passcode from the VoOhip
Lock Menu
When a channel or the HD-6000 is locked, figure 23
will display. To view a V-Chip blocked program or
to watch the program during a scheduled lock time,
you must enter your 4-digit passcode or change to
an unlocked channel or allowed program. Once you
have entered the passcode, the V-Chip Lock or Lock
by Time will remain released until the HD-6000 is
powered Off and then On again.
Figure 23. V-Chip Passcode screen
Using the VoChip from the Remote
Figure 24
You will see the screen shown below when you first
press V-CHIP on the remote control. To quickly turn
on or off the V-Chip Lock, input a four-digit passcode
with the number buttons on the remote control, then
press ENTER. To change any V-Chip settings, you
must use the V-Chip Lock Menu.
Figure 24, V-Chip Ent_v screen from Remote Control
79