Lubrication; Greasing The Bearings And Bushings - Toro 03781TE Operator's Manual

Maintenance For the week of:
Check Item
Mon.
Wash the
machine.
1. Check the glow plug and injector nozzles if the engine starts hard, produces excess smoke, or runs rough.
2. Immediately after every washing, regardless of the interval listed
Notation for Areas of Concern
Inspection performed by:
Item Date
1
2
3
4
5
6
7
8
Important:
Refer to your engine owner's manual and cutting unit Operator's Manual for additional
maintenance procedures.
Note:
Download a free copy of the electrical or hydraulic schematic by visiting www.Toro.com and searching
for your machine from the Manuals link on the home page.

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that must be
lubricated regularly with No. 2 lithium grease. If
you operate the machine under normal conditions,
lubricate all bearings and bushings after every 50
hours of operation or immediately after every washing.
The grease fitting locations and quantities are as
follows:
•
Brake shaft pivot bearings (5)
Tues.
Information
(Figure 41)
Wed. Thurs.
•
Rear axle pivot bushings (2)
39
Fri. Sat.
Figure 41
(Figure 42)
Sun.
g009704