Checking The Fluid Levels; Using The Gauge Bar; Applying The Ce Decals; No Parts Required - Toro 03781TE Operator's Manual

7

Checking the Fluid Levels

No Parts Required

Procedure
1. Check the level of the rear axle lubricant before
starting the engine for the first time, refer to
Checking the Oil Level of the Rear Axle (page
50).
2. Check the level of the hydraulic fluid before
starting the engine for the first time, refer to
Checking the Level of the Hydraulic Fluid (page
56).
3. Check the level of the engine oil before and
after starting the engine for the first time, refer to
Checking the Level of the Engine Oil (page
8

Using the Gauge Bar

Parts needed for this procedure:
1

Gauge bar

Procedure
Use the gauge bar to adjust the cutting unit. Refer to
the cutting unit Operator's Manual for the adjustment
procedures (Figure 24).
1. Gauge bar
2. Height-adjusting screw
3. Nut
42).
9

Applying the CE Decals

Parts needed for this procedure:
1

Warning decal

1

CE decal

1

Production year decal

Procedure
On machines requiring CE compliance, apply the
production year decal (Part No. 133-5615) near the
serial plate, the CE decal (Part No. 93-7252) near
the hood lock, and the CE warning decal (Part No.
138-1186) over the standard warning decal (Part No.
120-1683).
19
Figure 24
4. Holes used for setting the
groomer height of groom
(HOG)
5. Hole not used
g004552