Toro 03781TE Operator's Manual page 24

InfoCenter Icon Description (cont'd.)
Engine
Key switch
Indicates when the cutting units are
being lowered
Indicates when the cutting units are
being raised
PIN passcode
Hydraulic-fluid
Temperature—indicates the
hydraulic-fluid temperature
CAN bus
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
High: over allowed range
Low: under allowed range
Out of range
/
Switch
Operator must release switch
Operator should change to indicated
state
Symbols are often
combined to form
sentences. Some
examples are shown
below.
Operator should put machine in
neutral
Engine start denied
Engine shutdown
Engine coolant too hot
InfoCenter Icon Description (cont'd.)
Accessible only by entering PIN
Using the Menus
To access the InfoCenter menu system, press the
menu access button while at the main screen. This
will bring you to the main menu. Refer to the following
tables for a synopsis of the options available from
the menus:
Main Menu
Menu Item
Faults
Service
Diagnostics
Settings
About
Service
Menu Item
Hours
Counts
24
Hydraulic oil too hot
Sit down or set parking brake
Description
The Faults menu contains
a list of the recent machine
faults. Refer to the Service
Manual or your authorized
Toro distributor for more
information on the Faults
menu and the information
contained there.
The Service menu contains
information on the machine,
such as hours of use counters
and other similar numbers.
The Diagnostics menu
displays the state of each
machine switch, sensor and
control output. You can use
this to troubleshoot certain
issues as it tells you which
machine controls are on or off.
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.
Description
The hours menu lists the
total number of hours that the
machine, engine, and PTO
have been on, as well as the
number of hours the machine
has been transported and
when service is due.
The counts menu lists
numerous counts the machine
has experienced.