Cleaning; Washing The Machine - Toro 03781TE Operator's Manual

11. Repeat the procedure for all cutting units that
you want to backlap.
12. When finished, return the backlap levers to the
M position, lower the hood, and wash all
OW
lapping compound off the cutting units. Adjust
the cutting unit reel-to-bedknife as needed.
Move the cutting unit reel-speed controls to the
desired mowing position.
Important:
If you do not return the backlap
switch to the O
FF
the cutting units will not raise or function
properly.
Note:
Additional instructions and procedures on
backlapping are available in the Toro Sharpening
Reel and Rotary Mowers Manual, Form No.
80-300SL.
Note:
For a better cutting edge, run a file across
the front face of the bedknife after lapping. This
removes any burrs or rough edges that may
have built up on the cutting edge.
position after backlapping,

Cleaning

Washing the Machine

Wash the machine as needed using water alone
or with a mild detergent. You may use a rag when
washing the machine.
Important:
Do not use brackish or reclaimed
water to clean the machine.
Important:
Do not use power-washing equipment
to wash the machine. Power-washing equipment
may damage the electrical system, loosen
important decals, or wash away necessary grease
at friction points. Avoid excessive use of water
near the control panel, engine, and battery.
Important:
Do not wash the machine with the
engine running. Washing the machine with the
engine running may result in internal engine
damage.
60