Toro 03781TE Operator's Manual page 9

Note:
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. Review the instructions for operating the machine on slopes in the Operator's Manual as
well as the conditions in which you would operate the machine to determine whether you can operate the machine in the conditions
on that day and at that site. Changes in the terrain can result in a change in slope operation for the machine. If possible, keep the
cutting units lowered to the ground while operating the machine on slopes. Raising the cutting units while operating on slopes can
cause the machine to become unstable.
1. Warning—read the Operator's Manual; do not operate this
machine unless you are trained.
2. Warning—read the Operator's Manual before towing the
machine.
3. Tipping hazard—do not turn at high speeds; do not drive up
or down slopes greater than 16° .
4. Lower the cutting units when driving down slopes; use a
roll-over protection system and wear the seatbelt.
138-1186
(Affix over Part No. 120-1683 for CE)
5. Warning—do not park the machine on slopes; engage the
parking brake, lower the cutting units, shut off the engine, and
remove the ignition key before leaving the machine.
6. Thrown object hazard—keep bystanders away.
7. Entanglement hazard, belt—stay away from moving parts;
keep all guards and shields in place.
9
decal138-1186