1
Adjusting the Support
Rollers
No Parts Required
Procedure
Depending on what width cutting units are to be
installed on the traction unit, adjust the support rollers
as follows:
Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove the
key.
•
If you are using 27-inch cutting units, install the
rollers in the upper mounting holes of the support
assembly channels
•
If you are using 32-inch cutting units, install the
rollers in the lower mounting holes of the support
assembly channels
1. Support assembly channel 3. Use this hole for 32-inch
2. Use this hole for 27-inch
cutting units.
(Figure
3).
(Figure
3).
Figure 3
cutting units.
2
Installing the Hood Lock for
CE Compliance
Parts needed for this procedure:
1
Hood-lock bracket
2
Rivet
1
Screw (1/4 x 2 inch)
2
Flat washer (1/4 inch)
1
Locknut (1/4 inch)
Procedure
1.
Unhook the hood latch from the hood-latch
bracket
(Figure
1. Hood latch
g019541
2.
Remove the 2 rivets securing the hood-latch
bracket to the hood
12
4).
Figure 4
(Figure
5).
g200373