Toro 03781TE Operator's Manual page 16

Figure 15
1. Hex-socket screw
2. Pivot spacer
8. Lower all the lift arms completely.
9. Coat the carrier-frame shaft with clean grease
(Figure 16).
Figure 16
1. Lift-arm pivot yoke
2. Lift arm
3. Klik pin
g033150
3. Carrier frame
4. Flange locknut
g015976
4. Carrier-frame shaft
5. Thrust washer
10. For the front cutting units, slide a cutting unit
under the lift arm while inserting the shaft of
the carrier frame up into the lift-arm pivot yoke
(Figure 16).
Make sure that the thrust washer is in position
on the carrier-frame shaft.
11. Secure the carrier-frame shaft to the lift-arm
yoke with the klik pin
12. To lock (fix) the steering on the cutting units,
secure the pivot yoke to the carrier frame with
the snapper pin
1. Snapper pin
Note:
Use fixed steering when cutting on
side hills.
13. Use the following procedure on the rear cutting
units when the height of cut is above 19 mm
(3/4 inch).
A. Remove the lynch pin and washer securing
the lift-arm pivot shaft to the lift arm and
slide the lift-arm pivot shaft out of the lift
arm (Figure
1. Lift-arm pivot-shaft lynch pin and washer
B. Insert the lift-arm yoke onto the carrier
frame shaft
C. Insert the lift-arm shaft into the lift arm and
secure it with the washer and the lynch pin
(Figure 18).
16
(Figure 16).
(Figure 17).
Figure 17
18).
Figure 18
(Figure 16).
g015977
g003979