Adjusting The Lift-Arm Turnaround Position; Folding The Roll Bar - Toro 03781TE Operator's Manual

2. Insert a tube or similar object onto the long
spring end to relieve the spring tension during
the adjustment (Figure
CAUTION
The springs are under tension and could
cause personal injury.
Use caution when adjusting the springs.
3. While relieving the spring tension, remove the
bolt and locknut securing the spring actuator to
the bracket (Figure
1. Spring
4. Move the spring actuator to the desired hole
location and secure it with the locknut.
5. Repeat the procedure on the remaining spring.
Adjusting the Lift-Arm
Turnaround Position
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. The lift-arm switch is located behind the front
right lift arm (Figure
34).
34).
Figure 34
2. Spring actuator
35).
1. Switch
3. Loosen the switch mounting screws
and move the switch up to increase the lift-arm
turnaround height or move the switch down to
decrease the lift-arm turnaround height.
4. Tighten the mounting screws.
g015078

Folding the Roll Bar

You can fold the roll bar down to allow access into
areas of restricted height.
WARNING
The machine does not have a rollover
protection system (ROPS) when the roll bar is
folded down and should not be considered
a ROPS.
Do not wear a seatbelt when the roll bar is
lowered.
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Support the weight of the upper frame of the roll
bar while removing the snap pins and clevis pins
from the pivot brackets
31
Figure 35
(Figure
(Figure 36).
g015079
35)