Servicing The Engine Oil And Filter - Toro 03781TE Operator's Manual

below the Add mark on the dipstick, add oil to
bring the oil level to the Full mark. Do not overfill
the engine. If the oil level is between the Full and
Add marks, no oil addition is required.
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Unlock the hood latches and open the hood
(Figure 50).
Figure 50
1. Hood latch
3. Remove the dipstick, wipe it clean, install the
dipstick into the tube, and pull it out again.
The oil level should be in the safe range
51).
Figure 51
1. Dipstick
4. If the oil is below the safe range, remove the
fill cap (Figure 52) and add oil until the level
reaches the Full mark.
Important:
1. Oil-fill cap
Note:
from the crankcase before adding new oil.
5. Install the oil fill cap and dipstick.
6. Close the hood and secure it with the latches.
g200373
Servicing the Engine Oil
and Filter
Service Interval: Every 250 hours
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
(Figure
the engine, and remove the key.
2. Remove the drain plug
oil flow into a drain pan.
g008808
1. Drain plug
3. Install the drain plug when the oil stops.
4. Remove the oil filter
43
Do not overfill the engine.
Figure 52
When using different oil, drain all old oil
(Figure
Figure 53
(Figure 54).
g008809
53) and let the
g009713