Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that must be lubricated
regularly with No. 2 lithium grease. If the machine is operated
under normal conditions, lubricate all bearings and bushings
after every 50 hours of operation or immediately after every
washing.
The grease fitting locations and quantities are as follows:
•
Brake shaft pivot bearings (5)
Figure 48
•
Rear axle pivot bushings (2)
Figure 49
(Figure
48)
g009704
(Figure
49)
g009705
•
Steering cylinder ball joints (2)
1. Top fitting on king pin
•
Tie rod ball joints (2)
•
King pin bushings (2)
the king pin should only be lubricated annually
(2 pumps).
•
Lift arm bushings (1 per cutting unit)
•
Lift cylinder bushings (2 per cutting unit)
•
Lift arm pivot bushings (1 per cutting unit)
42
(Figure
50)
Figure 50
(Figure
50)
(Figure
50). The top fitting on
(Figure
51)
Figure 51
(Figure
(Figure
g009706
g015159
51)
52)