Toro 03781TE Operator's Manual page 15

Figure 13
1. Hose guide (left side
shown)
2. Rod bracket
1. Hose guides (each must lean toward the center cutting unit)
Note:
When installing or removing the
cutting units, make sure that the hairpin
cotter is installed in the spring-rod hole next
to the rod bracket. Otherwise, you must
install the hairpin cotter in the hole in the
end of the rod.
7. Increase the steering on the rear cutting units
by removing the 2 pivot spacers, hex-socket
screws, and flange locknuts
carrier frames of the rear cutting units (Cutting
Units 2 and 3); refer to
g015160
3. Nuts
(Figure 15) from the
Figure 12.
Figure 14
15
g019602