Huawei FusionModule2000 Maintenance Manual page 22

FusionModule2000 Smart Modular Data Center
Maintenance Guide
If the battery system is powered off for installation or commissioning or batteries
are not charged in time after discharge, recharge them in time by referring to the
instructions for recharging batteries with low SOC. Otherwise, batteries may be
damaged due to overdischarge.
● Batteries should be used soon after being deployed onsite. Batteries that have
● After the battery system is installed, fully charge batteries (the SOC must reach
The category 2 (C2) battery may cause radio interference when used in a
residential environment. Additional measures may be needed to prevent the
interference.
The category 3 (C3) battery is intended for commercial and industrial application
in the second class environment. Installation restrictions or additional measures
may be needed to prevent disturbances.
General Requirements
To ensure battery safety and battery management accuracy, use batteries provided
by the Company. The Company is not responsible for any battery faults caused by
batteries not provided by it.
●
●
●
●
Issue 02 (2022-07-30)
WARNING
CA UTION
been stored for an extended period should be recharged periodically.
Otherwise, they may be damaged.
100%) and then use them. Replace a battery only if it is faulty.
NO TICE
NO TICE
NO TICE
If a battery is accidentally exposed to water, do not install it. Move it to a safe
place for isolation and contact technical engineers in a timely manner.
Keep the battery switch off during installation and maintenance.
When installing batteries, do not place installation tools on the batteries.
After the installation is complete, clean up the objects on the batteries and
the surrounding area.
Use batteries of specified models. Using batteries of other models may
damage the batteries.
Copyright © Huawei Digital Power Technologies Co., Ltd.
1 Safety Information
15