Replacing An Ecc800-Pro - Huawei FusionPower6000 Maintenance Manual

FusionPower6000
Maintenance Guide
Figure 6-3 Removing a PSU
Step 2 Gently push the reserved PSU into the subrack along guide rails, and push the
locking latch rightwards to secure the handle.
Figure 6-4 Installing a PSU
----End

6.4 Replacing an ECC800-Pro

Prerequisites
●
●
Procedure
Step 1 Log in to the ECC800-Pro WebUI as an administrator.
Step 2 Use the Back Up Current Settings function to record the ECC800-Pro
configuration information or manually record the information.
Path: Maintenance > Configuration File > Back Up Current Settings
● If the main control module is damaged, you may fail to log in to the ECC800-Pro. In this
● The following information cannot be backed up: monitoring module IP address parameters,
Step 3 Turn off the upstream switch for the cabinet based on the electrical diagram and
labels, and record them.
Step 4 Mark the corresponding port names on the cables connected to the front and rear
of the ECC800-Pro, and then remove the cables.
Issue 02 (2022-07-18)
Tools: ESD wrist strap, ESD gloves, Phillips screwdriver, label, marker
Material: a new and intact ECC800-Pro of the same model
NO TE
case, you cannot back up the settings.
smart module certificate, management system certificate, management system second-
challenge password, time configuration parameters, access user management, access
permission management, device access certificate, log, and user configuration information.
Copyright © Huawei Digital Power Technologies Co., Ltd.
6 Component Replacement
45