Crankshaft Removal; Zeroing The Governor; Crankshaft Replacement - Toro 1P65F-2 Service Manual

Governor Assembly Installation (continued)

Zeroing the Governor

Crankshaft Replacement

Crankshaft Removal

Engine Lower End: Service and Repairs
11. Install the sump cover to the crankcase. Secure the crankcase with 7 (10
mm) bolts. Torque the bolts to 70–105 in-lbs. (8–12 Nm).
12. Turn the motor over.
13. Zero the governor.
1. Move the governor arm so the throttle plate at the carburetor is wide open.
2. Loosen the pinch bolt on the governor arm.
3. Using pliers, turn the governor shaft clockwise until it stops.
4. Tighten the pinch bolt.
1. Drain the oil.
2. Remove the 3 (10 mm) acorn nuts securing the recoil assembly to the top of
the engine. Remove the recoil assembly.
Figure 322
Page 9–18 1P65F-2 Service Manual
3429-270 Rev A