Alternator Test - Toro 1P65F-2 Service Manual

Charging System Removal (continued)

Alternator Test

Electrical System: Service and Repairs
9. Remove the fuel tank from the engine.
10. Remove the 2 (10 mm) mounting bolts securing the charge coil to the
crankcase.
11. Remove the charge coil from the crankcase.
1. Make sure the battery is fully charged.
2. Place the positive test lead from the volt meter to the positive terminal on
the mower battery.
3. Place the negative test lead from the volt meter to the negative test lead on
the battery.
4. Start the engine. Check the battery voltage. Voltage specification should be
13.2–16.2 VDC.
Figure 286
Figure 287
Page 8–18 1P65F-2 Service Manual
3429-270 Rev A