Toro 1P65F-2 Service Manual page 193

Charging System Installation
1P65F-2 Service Manual
3429-270 Rev A
1. Install the charge coil to the crankcase.
2. Install the 2 (10 mm) mounting bolts securing the charge coil to the
crankcase. Torque bolts to 90 in-lbs. (10 Nm). Set air gap to:
Air Gap: 0.0157 ± 3.007 in. (0.4–0.2 mm)
3. Install the fuel tank to the engine.
4. Install the 10 mm nut and washer to the fuel tank mounting stud. Torque nut
and washer to 90 in-lbs. (10 Nm).
5. Install the 2 shroud mounting studs securing the fuel tank to the crankcase.
Torque studs to 70–105 in-lbs. (8–12 Nm).
Figure 288
Figure 289
Page 8–19 Electrical System: Service and Repairs