Table 3.6 Types Of Interface Board And Applicable Slots; Interface Boards - Samsung OfficeServ 7200 Technical Manual

OfficeServ 7200
TECHNICAL MANUAL
• CRM: The CRM is supported on the MP20 processor only. This board performs the
same function as the RCM, RCM2, MFM and SCM (the SCM daughter board has been
discontinued as of 05/2009. The CRM daughter board is a replacement for this part). The CRM
in position 3 can only be set for DTMF tone detection. The CRM in position 2 can be set for
CID on FTMF. The board offers 14 CID receiver/transmitter and 16 DTMF receivers. A CRM
board located in position 3 will only support DTMF signalling.

3.3 INTERFACE BOARDS

This section describes how to set jumpers and switches of an interface board, how to install
optional daughterboards on an interface board, and how to install interface boards into
cabinet slots.
3.3.1 Installing Interface Boards
Interface boards may be installed in slot 1 through slot 5 of each cabinet with some
restrictions. The following table describes the slot locations for interface board type. The
locations of slot 0 through slot 5 of the cabinet are described in
Configuration'.
Category
Trunk Cards
Position 2
Figure 3.10 Installing Optional Boards
RCM or RCM2 or
CRM
Position 1
MIS
Figure 3.11 Installing Optional Daughterboard on MCP/MP20

Table 3.6 Types of Interface Board and Applicable Slots

Interface Board
TEPRI/TEPRIa
8TRK/8TRK2,16TRK
3.13
Home Page
Position 3 MFM
/ CRM
Position 1 MISC only.
Applicable Slot
Slot 3 through slot 5 of the main cabinet
Slot 3 of the expansion cabinet
Slot 1 through slot 5 of the main cabinet
Slot 1 through slot 5 of the expansion cabinet
Table of Contents
INSTALLATION
PART 3 MAY 2010
Section 3.1 'Cabinet