Selecting Installation Method; Installing In A Rack; Cautions For Installation; Tools Required - Samsung OfficeServ 7400 Installation Manual

CHAPTER 2. Ошибка! Стиль не определен.

2.2 Selecting Installation Method

The OfficeServ 7400 cabinet can be installed on the ground, inside a 19-inch rack
depending on the number of cabinets and environment of the installation area.
Caution for Installation
Only a trained service staff can install the OfficeServ 7400 system.

2.3 Installing in a Rack

This section describes how to install the OfficeServ 7400 cabinet inside a 19-inch rack

2.3.1 Cautions for Installation

Take the following cautions when installing the OfficeServ 7400 cabinet inside a rack:
The 19-inch rack should be a standard electric equipment rack.
When using an enclosed-type rack, check if the rack is properly ventilated. Vents
should be equipped on the side of the rack and fans should be attached to ventilate
cool air into the rack.
When using an enclosed-type rack, check if the rack is properly ventilated.
Vents should be equipped on the side of the rack and fans should be attached to
ventilate cool air into the rack.
When using an open rack, do not block the entrance of a port or fan of the OfficeServ
7400 system.

2.3.2 Tools Required

A middle-sized cross screwdriver
A bracket and three screws for attaching cabinet
Two brackets, six screws, six nuts for attaching rack
Two clamp screws
2-2

Figure 2.2 Tools for the Installation inside a Rack

© SAMSUNG Electronics Co., Ltd.