Mitsubishi Electric MELSEC iQ-R Series User Manual page 161

Step action wave output request
Wave
This area is for setting whether to start or end the wave output step action function for all channels in a batch.
Step action wave output request
OFF
ON
• The setting for this area is valid only in the wave output mode. In the other cases, changes of the value are ignored.
• Turning on the setting value (from (0) to (1)) changes the wave output status of all the channels where the D/A conversion
is enabled to the during wave output step action, and the wave output step action function is enabled.
• Turning off the setting value (from (1) to (0)) changes the wave output status to the wave output stop status, and the wave
output step action ends.
• Setting a value out of the setting range causes a step action wave output request setting range error (error code: 1D80H)
and does not change the wave output status.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Step action wave output request
■Default value
The default value is OFF (0).
Interrupt factor generation setting [n]
Normal
Set whether to send an interrupt request when the same interrupt factor occurs during the interrupt factor detection.
Setting value
0
1
• If a value other than the above is set, an interrupt factor generation setting range error (error code: 180H) occurs.
• When 'Interrupt factor generation setting [n]' (Un\G200 to Un\G215) is Interrupt resend request (0) and the same interrupt
factor occurs while the interrupt factor has been detected, an interrupt request is sent to the CPU module again.
• When 'Interrupt factor generation setting [n]' (Un\G200 to Un\G215) is No interrupt resend request (1) and the same
interrupt factor occurs while the interrupt factor has been detected, an interrupt request is not sent to the CPU module. To
send an interrupt request to the CPU module, do it after setting 'Interrupt factor reset request [n]' (Un\G156 to Un\G171) to
Reset request (1) and resetting the interrupt factor.
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name 1
Interrupt factor generation 200
setting [n]
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Interrupt resend request (0) for all areas.
CH1
188
Wave Synchronization
2 3 4 5 6
201 202 203 204 205
Setting value
0
1
CH2 CH3
Setting details
Interrupt resend request
No interrupt resend request
7 8 9 10 11
206 207 208 209 210
Appendix 3 Buffer Memory Areas
CH4
12 13 14 15 16
211 212 213 214 215
APPX
159
A