Mitsubishi Electric MELSEC iQ-R Series User Manual page 160

Interrupt factor mask [n]
Normal
Set whether to mask interrupt factors.
Setting value
0
1
When 'Interrupt factor mask [n]' (Un\G124 to Un\G139) is changed to Mask clear (interrupt used) (1) and an interrupt factor
occurs, an interrupt request is sent to the CPU module. When the set value is two or larger, the setting is regarded as Mask
clear (interrupt used) (1).
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Interrupt factor mask [n]
■Default value
The default value is Mask (interrupt unused) (0) for all areas.
Interrupt factor reset request [n]
Normal
Set whether to send the interrupt factor reset request.
Setting value
0
1
When Reset request (1) is set in 'Interrupt factor reset request [n]' (Un\G156 to Un\G171) corresponding to the interrupt factor,
the interrupt factor of the specified interrupt is reset. After that, 'Interrupt factor reset request [n]' (Un\G156 to Un\G171) turns
to No reset request (0). When the set value is two or larger, the setting is regarded as Reset request (1).
Turning on and off 'Operating condition setting request' (Y9) also resets interrupt factors.
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Interrupt factor reset request [n]
■Default value
The default value is No reset request (0) for all areas.
APPX
158
Appendix 3 Buffer Memory Areas
Wave
1 2 3 4 5
124 125 126 127 128
Wave
1 2 3 4 5
156 157 158 159 160
Synchronization
Setting details
Mask (interrupt unused)
Mask clear (interrupt used)
6 7 8 9
129 130 131 132
Synchronization
Setting details
No reset request
Reset request
6 7 8 9
161 162 163 164
10 11 12 13 14
133 134 135 136 137
10 11 12 13 14
165 166 167 168 169
15 16
138 139
15 16
170 171