Notice On Cat Mode - NEC UNIVERGE SV8300 Command Manual

NOTICE ON CAT MODE

(1) The CAT is used in on-line. Therefore, offline commands cannot be accessed from the CAT.
(2) To use the CAT after clearing all system data, perform the following operations on the system.
1. Plug a DLC blade into Slot01 accommodated in Unit01 (for Multiline Terminal).
2. Connect the CAT (Multiline Terminal) to Physical Port No. 010101 at the MDF or Virtual Port
No. 0000.
3. Set SENSE switch on the CPU blade accommodated in Unit01 to "A".
4. Press RESET switch on the CPU blade accommodated in Unit01.
5. Check the LED status.
• RUN LED lights and SYSD LED flashes while loading the standard system data.
• RUN LED and SYSD LED go off and S2 LED lights when the standard system data is loaded
normally.
• RUN LED and SYSD LED go off and ALM LED lights if the loading of the standard system
data fails. In that case, retry the above procedure 3-4.
NOTE 1:
All pre-set data is deleted when loading the standard system data.
NOTE 2:
When a call is connected to a line at loading the standard system data, the call is disconnected
at the point of pressing the RESET switch.
NOTE 3:
Pre-registered license data is maintained even if the standard system data is loaded.
NOTE 4:
The station call is not available by just loading the standard system data. Besides, the system
data setting for stations is required.
NOTE 5:
The standard system data is the data which shall be valid for the following data.
• Station number 300 (for Digital Multiline Terminal) for Physical Port number 010101
• Station number 301 (for IP Multiline Terminal) for Virtual Port number 0000 (for IP termi-
nal)
In addition, ensure that the Unit numbers 01-04 operate together. The standard system data
is loaded for using CAT features.
1-18
Chapter 1 HOW TO USE CAT
NOTICE ON CAT MODE
NWA-033623-001 Rev.8.1
APRIL/16/2010
91ch1001.fm