NEC UNIVERGE SV8300 Command Manual page 78

Hide thumbs Also See for UNIVERGE SV8300:

Table of Contents

COMMAND CODE TITLE:

Unit No. 01-50

SETTING OF SYSTEM SERVICES

Destination to receive the

synchronous signal for

DTI/PRT/CCT (First pri-

Assign this data when the system is a slave office and receives the clock syn-

chronization signal from the master office.

This data assignment is not required when the office is the master office.

When using the ISDN network, a system must be synchronized to ISDN clocks

for preventing from noise during calling, data transmitting error, and so on.

This data must be set when using the ISDN network.

Destination to receive the

synchronous signal for

DTI/PRT/CCT (Second

Assign this data when the system is a slave office and receives the clock syn-

chronization signal from the master office.

This data assignment is not required when the office is the master office.

When using the ISDN network, a system must be synchronized to ISDN clocks

for preventing from noise during calling, data transmitting error, and so on.

Maximum number of

channels for Speech syn-

thesis and Voice Response

Only Unit No. 01 (Y=10) can be set by this data.

When CF memory is used for Voice Response System, the number of channels

for Voice Response System (default: 8 channels) is that subtracted the number

of channels for Speech synthesis from the number of simultaneous usable

channels (16 channels).

Number of channels for

Speech synthesis

Continued on next page

NWA-033623-001 Rev.8.1

JANUARY/31/2012