NEC UNIVERGE SV8300 Command Manual page 526

COMMAND CODE TITLE:
71
(2) Limitation on Memory Slot Allocations
• In a single-tenant system, Tenant No. 00 can be assigned a maximum of 300 memory slots.
• Per Tenant:
Maximum of 300 memory slots
• For Hot Line-Outside/Delayed Hotline-Outside call:
Maximum of 100 memory slots (maximum number of Hot Lines/Delayed Hotlines)
• For Route Advance from Tie line to C.O. line/Direct-In Termination-CCIS:
Maximum of 64 memory slots (maximum number of Trunk Routes)
• For automatic fault information sending form built-in modem on CPU:
2 memory slots
(3) There is a maximum of 300 memory slots assigned by this command. However, if required,
another 1000-4000 memory slots can be added. These additional 1000-4000 memory slots are to
be assigned with CM08>110, 111, 112, 176, and CM73 and CM74.
(4) The abbreviated codes for System Speed Dialing are automatically determined by assigning this
command on a tenant basis, as shown below.
Tenant No. 00
(Memory (Abbreviated
Slot No.) Code)
000
001
002
019
(5) The Resident System Program allocates 100 memory slots to Tenant No. 01.
MEMORY ALLOCATION FOR SYSTEM SPEED DIALING
Tenant No. 01
(Memory
Slot No.)
00 020
01 021
02 022
19 034
(Abbreviated (Memory
Code)
00
01
02
14
3-470
Tenant No. 02
(Abbreviated
Slot No.) Code)
035 00
036 01
037 02
044 09
NWA-033623-001 Rev.8.1
CM71
91ch3005.fm
JUNE/15/2011