NEC UNIVERGE SV8300 Command Manual page 703

Hide thumbs Also See for UNIVERGE SV8300:

Table of Contents

COMMAND CODE TITLE:

Instant System

Changeover by man-

ual operation

For the Data "MMDDHHmm", enter the Month, Date, and Time (hour and minute) of the

time, as shown below.

MM : Month (01 (Jan.)-12 (Dec.))

DD : Date (01-31)

HH : Hour (00-23)

mm : Minute (00-59)

Set the same Unit No. and Slot No. assigned by the first data.

"00000000-FFFFFFFF" is displayed as the second data when this command is executed.

You can confirm the port status of the blade which is accommodated to the specified slot by

this data display.

00000000: All ports are not in use

Other than 00000000: Ports in use are included.

For the blade reset while the system is operating, be sure to check the port status. The blade

reset must be executed when all ports are not in use.

Set the CME0 Y=5>00 when setting the new IPT (P2P CCIS) after the IPT (P2P CCIS)

installation (this data cannot be used once the reset has been executed by this data).

This data setting has no effect on services other than related to IPT (P2P CCIS) even if the

reset (CME0 Y=5>00) is executed after the IPT (P2P CCIS) installation.

Set the CME0 Y=5>01 when changing the commands (CM10 Y=2, CMA7 Y=44, 46, and

50) which require a reset related to IPT (P2P CCIS).

RESET/INSTANT SYSTEM CHANGEOVER

TYPE OF RESET

SETTING DATA

Current time dis-

played on Multiline

Terminal/DESKCON

To request the reset

immediately.

Continued on next page

NWA-033623-001 Rev.8.1

JANUARY/14/2011