Drive Selection Mode; How To Select A Drive And Change Its Panel Link Id Number - ABB ACS800 Series Firmware Manual

20

Drive selection mode

In normal use the features available in the Drive Selection Mode are not needed; the
features are reserved for applications where several drives are connected to one
panel link. (For more information, see Installation and Start-up Guide for the Panel
Bus Connection Interface Module, NBCI, Code: 3AFY58919748).
In the Drive Selection Mode, the user can:
• Select the drive with which the panel communicates through the panel link.
• Change the identification number of a drive or panel connected to the panel link.
• View the status of the drives connected on the panel link.
The panel enters the Drive Selection Mode when the user presses the DRIVE key.
Each on-line station must have an individual identification number (ID). By default,
the ID number of the drive is 1.
Note: The default ID number setting of the drive should not be changed unless the
drive is to be connected to the panel link with other drives on-line.

How to select a drive and change its panel link ID number

Step
1.
2.
3.
Control panel
Action
To enter the Drive Selection Mode.
To select the next drive/view.
The ID number of the station is changed
by first pressing ENTER (the brackets
round the ID number appear) and then
adjusting the value with double-arrow
buttons. The new value is accepted with
ENTER. The power of the drive must be
switched off to validate its new ID number
setting.
The status display of all devices
connected to the Panel Link is shown after
the last individual station. If all stations do
not fit on the display at once, press the
double-arrow up to view the rest of them.
To connect to the last displayed drive and
to enter another mode, press one of the
mode selection keys.
The selected mode is entered.
Press Key
ACS 800
DRIVE
ASAAA5000 xxxxxx
ID NUMBER 1
ACS 800
ASAAA5000 xxxxxx
ID NUMBER 1
1o
Status Display
Symbols:
o = Drive stopped,
direction forward
= Drive running,
direction reverse
F = Drive tripped
on a fault
1 L -> 1242.0 rpm
PAR
ACT I
FREQ
FUNC
CURRENT
POWER
Display
75 kW
75 kW
45.00 Hz
80.00 A
75.00 %