Actual Signal Display Mode; How To Select Actual Signals To The Display - ABB ACS800 Series Firmware Manual

Actual signal display mode

In the Actual Signal Display Mode, the user can:
• show three actual signals on the display at a time
• select the actual signals to display
• view the fault history
• reset the fault history.
The panel enters the Actual Signal Display Mode when the user presses the ACT
key, or does not press any key within one minute.

How to select actual signals to the display

Step
1.
2.
3.
4.
5.a
5.b
Action
To enter the Actual Signal Display
Mode.
To select a row (a blinking cursor
indicates the selected row).
To enter the actual signal selection
function.
To select an actual signal.
To change the actual signal group.
To accept the selection and return to the
Actual Signal Display Mode.
To cancel the selection and keep the
original selection.
The selected keypad mode is entered.
Press Key Display
1 L -> 1242.0 rpm I
FREQ
ACT
CURRENT
POWER
1 L -> 1242.0 rpm I
FREQ
CURRENT
POWER
1 L -> 1242.0 rpm I
ENTER
1 ACTUAL SIGNALS
04 CURRENT
80.00 A
1 L -> 1242.0 rpm I
1 ACTUAL SIGNALS
05 TORQUE
1 L -> 1242.0 rpm I
ENTER
FREQ
TORQUE
POWER
1 L -> 1242.0 rpm I
ACT PAR
FREQ
CURRENT
POWER
FUNC DRIVE
13
45.00 Hz
80.00 A
75.00 %
45.00 Hz
80.00 A
75.00 %
70.00 %
45.00 Hz
70.00 %
75.00 %
45.00 Hz
80.00 A
75.00 %
Control panel