NEC iPASOLINK EX Advanced Instruction Manual page 735

5-8
Indication
Mute Status
ATPC Power Mode
FDB Full
RX Modulation
Total FDB Full
TX Modulation
CLK Status Changed
PTP Radio Clock Status
Maintenance
Equipment Start-up Status
Trap Suppression Status
ETH-Ring Status
ETH-Ring Cause
ETH-Ring Multi RPL Owner
Detect
ETH-Ring Port0 Status
ETH-Ring Port0 Loop Detect
ETH-Ring Port0 R-APS
Timeout
ETH-Ring Port1 Status
ETH-Ring Port1 Loop Detect
ETH-Ring Port1 R-APS
Timeout
PTP Sync. Time
PTP Clock Quality Level
Own Clock ID
GGS-000548-01E
Table 5-1 List of Conditions for Equipment
Category Description
Status Indicates that the control status of the RF TX Power Output is set
to MUTE.
Status Indicates that a failure of APTC control signal (for 90 seconds), or
a status of MAX Power (for 90 seconds) has been detected.
Status FDB Full indication is specified per VLAN.
Status Indicates that the modulation system at the receiving side has
been changed.
Status Dynamic Entry in L2Switch has reached the maximum number.
Status Indicates that the modulation system of MODEM at the
transmitting side has been changed.
Status Indicates that a change has been made to Reference Clock.
Status Indicates the PTP Radio Clock Status.
Status Indicates that the system is set int the Maintenance mode.
Status Indicates that the equipment is started up, or rebooted, and
reports the cause.
Status indicates the state of Trap Suppression function.
Status Indicates the state of the ETH-Ring.
Status Indicates the ETH-Ring State changes.
Status Indicates that the system detects the multiple settings of ETH-
Ring RPL.
Status Indicates that the state changes of the Port configuring ETH-
Ring.
Status Indicates that the system detects loops in ETH-Ring traffic.
Status Indicates that the time out for receiving R-APS message occurs
at the node that configures ETH-Ring and has no locked-out
ports.
Status Indicates that the state changes of the Port configuring ETH-
Ring.
Status Indicates that the system detects loops in ETH-Ring traffic.
Status Indicates that the time out for receiving R-APS message occurs
at the node that configures ETH-Ring and has no locked-out
ports.
Status Indicates the time of synchronizing with Master when using the
PTP function.
Status Indicates the level of PTP Clock Quality.
Status Indicates the PTP Clock of the equipment.
CORRECTIVE MAINTENANCE
iPASOLINK EX Advanced: O & M
PERATION AINTENANCE