Security Management; Overview; Snmpv1; Get/Set Of Mib - NEC iPASOLINK EX Advanced Instruction Manual

SECURITY MANAGEMENT

3.1 Overview

iPASOLINK supports the following protocols and security management functions:

3.1.1 SNMPv1

SNMPv1 (Simple Network Management Protocol Version 1) is a communication
protocol to monitor/control NEs on an IP network, which is specified by the
following RFCs:
RFC No.
RFC 1155
RFC 1157
RFC 1213
iPASOLINK enables SNMPv1 to support the following functions:
3.1.1.1
Following are responses to the request of PDU (Protocol Data Unit) supported by
SNMPv1. Up to ten SNMP managers including the setting of IP address, community
name, security settings, etc., can be registered via the WebLCT. By default,
iPASOLINK uses the port 161 to receive the SNMP request PDU. To use any other
port but the default port, change the settings via the WebLCT.
Item
GetRequest
GetNextRequest
GetResponse
SetRequest
Trap
iPASOLINK EX Advanced: S
3. SECURITY MANAGEMENT
Table 3-1 RFC Standards
Title
Structure and Identification of Management Information on TCP/IP-based
Internets (SMIv1)
A Simple Network Management Protocol (SNMP)
Management Information Base on Network Management of TCP/IP-based
internets: MIB-II

GET/SET of MIB

Table 3-2 PDU Supported by SNMPv1
Description
Requests the specified instance value.
Requests the subsequent instance value of specified instance value in the list.
Responds to the corresponding GetRequest and Set Request.
Sets the specified instance value.
Informs the change of state and troubles (SNMPv1-Trap).
N S P
ET ETWORK AND YSTEM ROVISIONING
3-1
GGS-000547-01E