NEC iPASOLINK EX Advanced Instruction Manual page 517

8-198
Parameter
Send LLF Signal
Ignore Received LLF
Signal
Edge Port Setting
——
OAM Send Port Setting
5. Following dialog box appears. Click the
Figure 8-276 Information Dialog Box
6.
Figure 8-277 Information Dialog Box
7. The
Figure 8-278 LLF Setting Window
GGS-000547-01E
Table 8-50 LLF Setting Parameters (2 of 2)
Value
Enable
Enable
Disable
(check box)
OAM Send Port Setting option is added for the operation regarding IEEE802.3ah
(LINK OAM), which is currently not supported by iPASOLINK EX/A. All check
boxes must be unticked. If checked, LLF function does not operate properly, e.g.,
LLF will not shut down an Ethernet Port by detecting a Trunk Port failure.
Information
dialog box appears. Click the
window updates the information.
LLF Setting
This step ends the procedure.
Description
Enables sending the LLF Signals.
(This option is currently not editable.)
Ignores a received LLF Signal.
Accepts received LLF Signal.
Tick the check box to set the port as Edge Port.
OK
button to proceed.
OK
iPASOLINK EX Advanced: S
Set ETH Function
button to proceed.
N S
ET ETWORK AND YSTEM
P
ROVISIONING