Making The Electrical Connections; Connecting The Line Power - GE TransPort PT900 User Manual

2.6 Making the Electrical Connections

Before taking measurements with the PT900, you must make all the necessary
cable connections to the transmitter. To wire your transmitter, complete the
following sections:
•
Connecting the Line Power (see page 33)
•
Connecting the Transducers (see page 35)
•
Connecting the Digital Output (see page 36)
•
Connecting the Analog Inputs and Output (see page 37)
•
Using the USB Port (see page 38)
•
Using the Bluetooth Wireless Interface (see page 38)
Note: For basic operation, you only need to connect the Transducer cables. The
I/O connections are required only if you intend to use those features.
After the PT900 is completely wired, proceed to Chapter 3, Initial Setup, to
configure the meter for operation.

2.6.1 Connecting the Line Power

An example of the PT900 transmitter product label is shown in Figure 43 below.
Be sure to power the transmitter only with the voltage specified on the label.
®
TransPort PT900 User's Manual
Figure 43: PT900 Transmitter Label
Chapter 2. Installation
33