GE TransPort PT900 User Manual page 35

2.5.5 Installing the Transducers (cont.)
6. Slide a transducer, which is already locked into its transducer holder, into
one of the clamp-on fixture's clamp holders until the plunger from the top
of the transducer holder snaps into its position on the bottom of the clamp
holder (see Figure 21 below).
Important: The cable connectors on the mounted transducers must point away
from each other and toward opposite ends of the clamp-on fixture. To
assist in this requirement, the arrows on the end pieces help to
indicate the cable connector direction.
®
TransPort PT900 User's Manual
Figure 21: Inserting the Transducer
Chapter 2. Installation
19