GE TransPort PT900 User Manual page 28

Chapter 2. Installation
2.5.3 Mounting the Clamp-On Fixture (cont.)
5. Verify that the pipe rests in the small cutout slot on the bottom of the end
pieces (see Figure 12 below). Also, be sure that the scale markings on the
rail rod of the clamp-on fixture can be easily read after the installation has
been completed.
6. To install a chain around the pipe, refer to Figure 13 on page 13 and
complete the following steps:
a. Identify the chain screw mechanism, the end flat and the chain slot on
the clamping fixture end piece closest to the reference pipe fitting.
b. Unscrew the chain screw mechanism, then wrap the metal chain all
the way around the pipe.
c. Push down on the top of the chain screw mechanism and hold it
down. Then, pull the chain so that it is snug around the pipe and slide
the chain into the small slot located at the opposite side of the end
piece from the chain screw mechanism.
d. Release the chain screw mechanism and tighten it just enough to
remove any slack in the chain.
12
Slot
Figure 12: Cutout Slot
®
TransPort PT900 User's Manual