Displaying Multiple Measurements - GE TransPort PT900 User Manual

5.3 Viewing Measurements (cont.)
Clicking any measurement on the measurement screen will open a popup dialog
box for changing the decimal format for that measurement (see Figure 92 below).
1. Select the desired decimal format from the drop-down list.
2. Select the desired number of decimal places from the drop-down list.
3. Click OK to confirm the selections, or click CANCEL to discard the
changes.

5.3.1 Displaying Multiple Measurements

The default measurement screen is a multi-measurement format, which means that
all measurements which have been set up are displayed on one page with scrolling
capability. An indication of this display type is the highlighted
top of the screen (see Figure 91 on page 94). Note the following:
•
You may click the EDIT button at the top right of the screen at any time to
open the SET UP MEASUREMENTS menu.
•
An Error Status box is located just above the measurement display section
of the screen. If there are no system errors, No Error is displayed (see
Figure 91 on page 94). However, if a system error does occur, the error
information is displayed in this location with a flashing red background.
®
TransPort PT900 User's Manual
Figure 92: Setting the Decimal Format
Chapter 5. Measurements
icon at the
95