Checking The Transducer Holders - GE TransPort PT900 User Manual

Chapter 2. Installation

2.5.4 Checking the Transducer Holders

Before installing the transducers into the clamp-on fixture, a transducer holder must
be attached to the each transducer. A transducer holder is installed on each
transducer by GE prior to shipment. Verify that your transducers have their holders
already installed and that they are secure. If so, you may skip this section.
A complete transducer assembly includes the following components:
•
Clamp Holder:
•
Transducer Holder:
•
Transducer:
transducer holder and secured with set screws. During mounting, the
transducer holder slides into the clamp holder and attaches with a plunger
If for some reason a transducer's holder was not installed or has been removed,
refer to Figure 17 below and reinstall the holder as follows:
1. Slide the holder onto the top of the transducer so that the circle slots near
the top of the transducer sides are closely aligned with the filled holes on
the side of the transducer holder.
2. Screw the hex socket set screws from the transducer holder into the holes
of the transducer. These screws will lock the holder into place.
16
Permanently attached to the fixture clamp
Semi-permanently attached to the transducer
Prior to mounting, the transducer is installed into the
Hex Socket
Set Screw
Transducer Holder
Transducer
Figure 17: Transducer Assembly
Clamp
Holder
Hex Socket Set Screw
®
TransPort PT900 User's Manual