Connecting A Usb Device - Huawei 5288 V3 V100R003 User Manual

5288 V3 Server
User Guide
Figure 3-25 Connecting an SFP+ cable
Step 6 Check that the new cable is properly connected.
Power on the device, and ping the IP address of the peer device connected over the new cable.
If the peer device cannot be pinged, check that the cable is intact or the connector is securely
connected.
Step 7 Bind the new optical cable.
Bind the new optical cable in the same way as existing optical cables. You can also remove all
cable ties and bind all of the optical cables again if necessary.
----End

3.5.4 Connecting a USB Device

Check that data has been copied to the USB device to be connected.
Procedure
Step 1 Locate the server to which the USB device is to be connected.
Step 2 Connect the USB storage device to the USB port on the server, as shown in
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd.
3 Installing and Removing the 5288 V3
Figure 3-26.
75