Powering On And Off The Server; Powering On The Server - Huawei 5288 V3 V100R003 User Manual

5288 V3 Server
User Guide
About This Chapter
This topic describes the procedures for powering on and off the server.

4.1 Powering On the Server

4.2 Powering Off the Server
4.1 Powering On the Server
Power on the server using the iBMC WebUI.
Before powering on the server, you need to obtain the IP address of the iBMC management
network port, and the user name and password for logging in to the iBMC WebUI. For details
about how to obtain the IP address for the management network port and how to operate the
iBMC, see
Before powering on the server, pay attention to the following precautions:
l
l
l
The methods for powering on the server are as follows, depending on the power status of
power supply units (PSUs):
l
l
Issue 26 (2018-11-19)
4

Powering On and Off the Server

HUAWEI Rack Server iBMC User
Before the power-on, disconnect the power supply to the server, and check that all cables
are connected correctly and the power supply voltage meets the requirements.
During the power-on, do not remove or insert hard disks or cables, such as the network
cable and Console port cable.
Wait for at least 1 minute before powering on a server that has just been powered off.
If PSUs are properly installed and not powered on, power on the server as follows:
Connect the external power supply to PSUs. Then the server will power on with PSUs.
NOTE
The default value of Power Strategy is Turn on, which indicates that the server automatically powers
on after power is supplied to PSUs. To change the value of Power Strategy, log in to the iBMC WebUI
and choose Power > Power Control.
If PSUs are powered on and the server is in the standby state, power on the server as
follows:
Copyright © Huawei Technologies Co., Ltd.
4 Powering On and Off the Server
Guide.
89