Huawei 5288 V3 V100R003 User Manual page 100

5288 V3 Server
User Guide
Procedure
Power on the server using the iBMC WebUI.
1.
2.
3.
Verification
Check the indicator status after the server is powered on.
Issue 26 (2018-11-19)
NOTE
When the power indicator is steady yellow, the server is in the standby state.
– Press the power button on the front panel to power on the server. For details about
the power button position, see
– Power on the server using the iBMC WebUI. For details, see
Server.
– Power on the server using the iBMC command-line interface (CLI) in remote
management mode.
Log in to the iBMC CLI. For details, see
Run the ipmcset -d powerstate -v 1 command on the iBMC CLI to power on the
server remotely.
Log in to the iBMC WebUI. For details, see
Choose Power > Power Control.
The Power Control page is displayed, as shown in
Figure 4-1 Power Control page
Click Power On. In the displayed dialog box, click Yes to power on the server.
Copyright © Huawei Technologies Co., Ltd.
4 Powering On and Off the Server
2.2 Appearance.
9.3-Logging In to the iBMC
9.2 Logging In to the iBMC
Figure
4.1 Powering On the
CLI.
WebUI.
4-1.
90