•
Settings applied
•
Number of terminals connected to the L2MS slave
•
Information of terminals connected to the L2MS slave (in the case of a switch)
•
MAC address
•
Ports connected
•
Time at which terminal was discovered
•
Information of terminals connected to the L2MS slave (in the case of an AP)
•
SSID connected
•
Frequency connected
•
Time at which terminal was discovered
•
If L2MS is operating as slave
•
Whether managed by the L2MS master
•
MAC address of L2MS master (if managed)
[Note]
Information is not shown if L2MS is not operating.
Specifying "detail" is valid only if L2MS is operating as master.
[Example]
If L2Ms is operating as master, show detailed L2MS information.
SWR2311P>show l2ms detail
Role : Master
[Master]
Number of Terminals
[Slave]
Number of Slaves
[ac44.f230.00a5]
Model name
Device name
Route
LinkUp
Uplink
Downlink
Config
Appear time
Number of Terminals : 1
[bcae.c5a4.7fb3]
Port
Appear time
[00a0.deae.b8bf]
Model name
Device name
Route
LinkUp
Uplink
Downlink
Config
Appear time
Number of Terminals : 0
4.20.11 Set the device information acquisition time interval for downstream of a wireless AP
[Syntax]
wireless-terminal-watch interval time
no wireless-terminal-watch interval
[Parameter]
time
[Initial value]
wireless-terminal-watch interval 60
: 0
: 2
: SWR2311P-10G
: SWR2311P-10G_Z5301050WX
: port2.1
: 1, 3, 9
: 1
: 3
: None
: Tue Mar 13 18:43:18 2018
: 9
: Wed Mar 14 14:01:18 2018
: SWR2311P-10G
: SWR2311P-10G_S4L000401
: port2.1-3
: 1
: 1
: None
: None
: Tue Mar 13 18:43:18 2018
:
<10-86400>
Acquisition interval (seconds)
Command Reference | Maintenance and operation functions | 99