Set Remarking Of Individual Policers - Yamaha L2 Command Reference Manual

SWR2311P(config-pmap-c)#remark-map yellow ip-dscp 10
SWR2311P(config-pmap-c)#exit
SWR2311P(config-pmap)#exit
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#service-policy input policy1

9.2.28 Set remarking of individual policers

[Syntax]
remark-map color type value
no remark-map
[Parameter]
color
type
value
[Input mode]
policy map class mode
[Description]
Specifies remarking operations for bandwidth classes Yellow and Red that were classified by individual policers. In addition,
reassign the egress queue according to the egress queue ID table that corresponds to the trust mode.
For remarking, you can select either CoS value, TOS precedence, or DSCP value.
If this is executed with the "no" syntax, the remarking setting is deleted.
In order to perform remarking, you must specify this command and additionally use the police command (policy map class
mode)) to specify "remark" as the action for the corresponding bandwidth class.
[Note]
In order to execute this command, QoS must be enabled.
Remarking can be used in conjunction with pre-marking and specifying the egress queue.
Up to four user-defined values may be used for pre-marking/remarking to a DSCP value not recommended in the RFC. The
following table shows the DSCP values that are recommended in the RFC.
PHB
default
Class Selector
Assured Forwarding
Expedited Forwarding(EF)
: Bandwidth class to remark
Setting value
yellow
red
: Type of remarking
Setting value
cos
ip-precedence
ip-dscp
: <0 - 7>
CoS or TOS precedence remarking value
: <0 - 63>
DSCP remarking value
DSCP value
0
0, 8, 16, 24, 32, 40, 48, 56
10, 12, 14, 18, 20, 22, 26, 28, 30, 34, 36,
38
46
Command Reference | Traffic control | 245
Description
Make remarking settings for bandwidth class
Yellow
Make remarking settings for bandwidth class
Red
Description
CoS remarking
TOS precedence remarking
DSCP remarking
RFC
2474
2474
2597
2598