Set Poe Port Power Supply Priority; Show Poe Power Supply Information - Yamaha L2 Command Reference Manual

[Description]
Sets the description text of the PD device to connect to PoE port.
[Note]
The description text that was set is shown with the show power-inline command.
[Example]
Set the description of the PD device connected to port1.1 as "AP1".
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#power-inline description ap1

5.6.4 Set PoE port power supply priority

[Syntax]
power-inline priority priority
no power-inline priority
[Parameter]
priority
[Initial value]
power-inline priority low
[Input mode]
interface mode
[Description]
Sets the power supply priority for PoE port.
If the amount of power used by the PoE power supply has exceeded the maximum, power supply will stop for the port with the
lowest priority.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
Power supply priority is shown using the show power-inline command.
[Example]
Set the power supply priority for port1.5 to high.
SWR2311P(config)#interface port1.5
SWR2311P(config-if)#power-inline priority high

5.6.5 Show PoE power supply information

[Syntax]
show power-inline
show power-inline interface ifname
[Parameter]
ifname
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the PoE port power supply information.
Specifying ifname will show detailed information for the specific PoE port.
: Power supply priority
Setting value
critical
high
low
: PoE port
Command Reference | Interface control | 155
Description
Highest
High
Low