Set Terminal Management Function; Set The Device Information Acquisition Time Interval - Yamaha L2 Command Reference Manual

96 | Command Reference | Maintenance and operation functions
[Initial value]
slave-watch down-count 3
[Input mode]
L2MS mode
[Description]
Sets the number of query frames that are transmitted without receiving a response frame from the slave until it is determined
that the L2MS slave is down.
If this command is executed with the "no" syntax, the setting returns to the default.
If the number of query frames specified by count have been transmitted without receiving a response frame from the slave, it is
determined that the corresponding L2MS slave is down.
[Note]
If the port to which the L2MS slave is connected is in a link-down state, determining that the L2MS slave is down might take a
shorter time than the setting of this command.
Slave watch is performed only if L2MS is operating as master.
[Example]
Specify "8" as the count used to determine that the slave is down.
SWR2311P(config)#l2ms configuration
SWR2311P(config-l2ms)#l2ms enable
SWR2311P(config-l2ms)#l2ms role master
SWR2311P(config-l2ms)#slave-watch down-count 8

4.20.6 Set terminal management function

[Syntax]
terminal-watch enable
terminal-watch disable
no terminal-watch
[Keyword]
enable
disable
[Initial value]
terminal-watch disable
[Input mode]
L2MS mode
[Description]
Enables the terminal management function. If this is enabled, information about the devices existing on the network is obtained
at regular intervals.
If this command is executed with the "no" syntax, disable terminal management function.
[Note]
Terminal management is performed only if L2MS is operating as master.
[Example]
Enable the terminal management function.
SWR2311P(config)#l2ms configuration
SWR2311P(config-l2ms)#l2ms enable
SWR2311P(config-l2ms)#l2ms role master
SWR2311P(config-l2ms)#terminal-watch enable

4.20.7 Set the device information acquisition time interval

[Syntax]
terminal-watch interval time
no terminal-watch interval
: Enable terminal management function
: Disable terminal management function