Yamaha L2 Command Reference Manual page 117

[Parameter]
type : Interface type
port
vlan
sa
po
index : Index number
S.X
<1－4094>
<1－96>
<1－127>
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the status of the interface specified by ifname. If ifname is omitted, shows the status of all interfaces.
The following items are shown.
Interface
Link is
Hardware is
HW addr
Description
ifIndex
MRU
ARP ageing timeout
Speed-Duplex
Auto MDI/MDIX
IPv4 address
broadcast
Switchport mode
Interface type
Interface ID
Item
Command Reference | Interface control | 117
Description
Physical interface
VLAN interface
Static logical interface
LACP logical interface
Description
Specifies the stack ID (S) of the physical
interface, and the number printed on the chassis
(X). * The SWR2311P is fixed as stack ID=1.
Specify the VLAN ID.
Speciffy the static logical interface number.
Specify the LACP logical interface number.
Description
Interface name
Link status *2 (if shutdown, shows the
cause)
• If shutdown is specified : (by
shutdown)
• If port error is detected : (by err-
disable)
Interface type (e.g., Ethernet, VLAN)
Physical (MAC) address *1
Description of interface
Interface index number
Maximum Receive Unit *4
ARP timeout time (time that ARP
entries are maintained) *3
Speed and duplex mode settings, and
operating status *1
Auto MDI/MDIX enabled/disabled *1
IP address/mask length *3 (shown only
if IP address is set)
IP broadcast address *3 (shown only if
IP address is set)
Mode of the switchport
• access : untagged