Ipv6 Address Management; Set Ipv6; Set Ipv6 Address - Yamaha L2 Command Reference Manual

1 192.168.10.1 (192.168.10.1)
2 192.168.20.1 (192.168.20.1)
3 192.168.30.1 (192.168.30.1)
4 192.168.40.1 (192.168.40.1)
5 192.168.50.1 (192.168.50.1)
6 192.168.100.1 (192.168.100.1)

7.5 IPv6 address management

7.5.1 Set IPv6

[Syntax]
ipv6 switch
no ipv6
[Parameter]
switch
[Initial value]
ipv6 disable
[Input mode]
interface mode
[Description]
Enables IPv6 for the VLAN interface and automatically sets the link local address.
IPv6 addresses can be assigned to a maximum of 8 VLAN interfaces.
If IPv6 is disabled, related settings are also simultaneously deleted.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
The automatically-specified link local address can be viewed by using the show ipv6 interface brief command.
[Example]
Enable IPv6 for VLAN #1.
SWR2311P(config)#interface vlan1
SWR2311P(config-if)#ipv6 enable

7.5.2 Set IPv6 address

[Syntax]
ipv6 address ipv6_address/prefix_len
no ipv6 address
[Parameter]
ipv6_address
prefix_len
[Input mode]
interface mode
[Description]
Specifies the IPv6 address and prefix length for the VLAN interface.
An IPv6 address can be set for a VLAN interface for which the ipv6 enable command has been set.
One global address and one link local address can be set for one VLAN interface.
: Behavior of the IPv6
Setting value
enable
disable
: X:X::X:X
IPv6 address
: <1-127>
IPv6 prefix length
0.563 ms 0.412 ms
0.561 ms 0.485 ms
0.864 ms 0.693 ms
0.751 ms 0.783 ms
7.689 ms 7.527 ms
33.948 ms 10.413 ms
Command Reference | Layer 3 functions | 199
0.428 ms
0.476 ms
21.104 ms
0.673 ms
7.168 ms
7.681 ms
Description
Enable the IPv6
Disable the IPv6