Set Notification Type To Transmit - Yamaha L2 Command Reference Manual

user
[Initial value]
none
[Input mode]
global configuration mode
[Description]
Set the destination of SNMP notifications.
Up to 8 entries can be specified.
If this command is executed with the "no" syntax, the specified destination hosts are deleted.
[Note]
Note that if this is specified as an IPv6 link local address, and you add a setting that specifies a different transmitting interface
for the same address, the combination of address and transmitting interface is considered to have changed, and all settings of the
old combination are deleted. For example if there are multiple settings that specify "fe80::10%vlan1" and you newly add the
setting "fe80::10%vlan2," all settings for "fe80::10%vlan1" are deleted, and only the settings of the added "fe80::10%vlan2"
will remain.
[Example]
Using SNMPv1, set 192.168.100.11 as the destination for traps. Set "snmptrapname" as the trap community name.
SWR2311P(config)#snmp-server host 192.168.100.11 traps version 1 snmptrapname
Using SNMPv2c, set 192.168.100.12 as the destination for notifications. Specify the notification type as informs, and the
notification screen community name as "snmpinformsname".
SWR2311P(config)#snmp-server host 192.168.100.12 informs version 2c snmpinformsname
Using SNMPv3, set 192.168.10.13 as the destination for notifications. Set the notification type to traps, set the security level for
transmission to priv, and set the user name to "admin1".
SWR2311P(config)#snmp-server host 192.168.10.13 traps version 3 priv admin1

4.10.2 Set notification type to transmit

[Syntax]
snmp-server enable trap trap_type [trap_type]
no snmp-server enable trap
[Parameter]
trap_type
Setting value
priv
: User name (maximum 32 characters)
This can be specified only if version is '3'
: Type of trap
Setting value
coldstart
warmstart
linkdown
linkup
authentication
l2ms
errdisable
Command Reference | Maintenance and operation functions | 51
Authentication / Encryption (authPriv)
When the power is turned on/off, when firmware
is updated, or when the cold start command is
executed
At restart
At linkdown
At linkup
When authentication fails
When L2MS slave is detected or lost
When ErrorDisable is detected or canceled
Description
Description