Flow Control; Set Flow Control (Ieee 802.3X Pause Send/Receive) (System); Set Flow Control (Ieee 802.3X Pause Send/Receive) (Interface) - Yamaha L2 Command Reference Manual

258 | Command Reference | Traffic control
Input value
18 - 23476
23477 - 1000000
[Example]
Reduce transmission from queue #0 of LAN port #1 down to CIR:10 Mbps and Bc:64000 byte.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#traffic-shape queue 0 rate kbps 10000 burst 64

9.3 Flow control

9.3.1 Set flow control (IEEE 802.3x PAUSE send/receive) (system)

[Syntax]
flowcontrol type
no flowcontrol
[Parameter]
type
[Initial value]
no flowcontrol
[Input mode]
interface mode
[Description]
Enables flow control for the entire system (IEEE 802.3x PAUSE frames send/receive).
If this is executed with the "no" syntax, flow control is disabled.
[Note]
If the QoS function is enabled, it is not possible to enable flow control for the system.
If flow control is enabled, the tail drop function is automatically disabled.
Flow control for each interface operates only if the flow control settings of the system and of the interface are each enabled.
[Example]
Enable flow control for system.
SWR2311P(config)#flowcontrol enable

9.3.2 Set flow control (IEEE 802.3x PAUSE send/receive) (interface)

[Syntax]
flowcontrol type
no flowcontrol
[Parameter]
type
: Flow control operation
Setting value
enable
disable
: Flow control operation
Setting value
auto
both
disable
Traffic rate granularity (kbps)
17.28
261
Enables flow control
Disables flow control
Enable flow control auto negotiation
Enable transmission/reception of Pause frames
Disable flow control
Description
Description