Chapter 1: How To Read The Command Reference; Applicable Firmware Revision; How To Read The Command Reference; Interface Names - Yamaha L2 Command Reference Manual

Chapter
1

How to read the command reference

1.1 Applicable firmware revision

This command reference applies to firmware Yamaha Intelligent L2 Switch SWR2311P of Rev.2.02.09.
For the latest firmware released after printing of this command reference, manuals, and items that differ, access the following
URL and see the information in the WWW server.
http://www.rtpro.yamaha.co.jp
1.2 How to read the command reference
This command reference describes the commands that you enter from the console of the Yamaha Intelligent L2 Switch
SWR2311P.
Each command is described by a combination of the following items.
[Syntax]
[Keywords]
[Parameters]
[Default setting]
[Input mode]
[Description]
[Notes]
[Examples]

1.3 Interface names

In the command input syntax, interface names are used to specify each interface of the switch.
The following interface names are handled by the SWR2311P.
Interface type
LAN/SFP port
VLAN interface
static logical interface
LACP logical interface
Prefix
port
vlan
sa
po
Command Reference | How to read the command reference | 13
Explains the command input syntax. Key input can use either
uppercase or lowercase characters.
Command names are shown in bold (Bold face).
The parameter portion is shown in italic (Italic face).
Keywords are shown in normal characters.
Parameters that can be omitted are enclosed in square
brackets ( [ ] ).
Explains the type and significance of keywords that can be
specified for the command.
Explains the type and significance of parameters that can be
specified for the command.
Indicates the factory-set state of the command.
Indicates the modes in which the command can be executed.
Explains the command.
Explains points that you should be aware of when using the
command.
Provides specific examples of the command.
Description
Used to specify a physical
port. Specify "stack ID" + "."
+ "port number" after the port
number. * The SWR2311P is
fixed as stack ID=1.
Used to specify a VLAN.
Specify vlan followed by the
"VLAN ID".
Used to specify link
aggregation that combines
multiple LAN/SFP port.
Specify sa or po followed by
"logical interface ID".
Examples
When specifying LAN port
#1 on LAN port stack #1 :
port1.1
To specify VLAN #1:vlan1
o specify static logical
interface #1: sa1
To specify LACP logical
interface #2: po2