Track Interface Line-Protocol - Dell C9000 Series Reference Manual

Related
Commands

track interface line-protocol

Configure object tracking on the line-protocol state of a Layer 2 interface.
C9000 Series
Syntax
track object-id interface interface line-protocol
To return to the default setting, use the no track object-id command.
Parameters
object-id
interface
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
• The status of the IPv4 interface is UP only if the Layer 3 status of the interface is
UP and the interface has a valid IP address.
• The Layer 3 status of an IPv4 interface goes DOWN when its Layer 3 status goes
down (for a Layer 3 VLAN, all VLAN ports must be down) or the IP address is
removed from the routing table.
• show track – displays information about tracked objects, including configuration,
current state, and clients which track the object.
• track interface line-protocol
state of a Layer 2 interface.
Enter the ID number of the tracked object. The range is 1 to 500.
Enter one of the following values:
•
•
•
•
•
– configures object tracking on the line-protocol
For a 1-Gigabit Ethernet interface, enter
gigabitethernet and the slot-number/ port-number.
For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
For a port channel interface, enter the keywords port-
channel then a number.
For a 10-Gigabit Ethernet interface, enter
tengigabitethernet and the slot-number/ port-
number.
For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Object Tracking 1467