Jumping To End - Mitsubishi Electric MELSEC iQ-R Series Programming Manual

Jumping to END

GOEND
RnPCPU
RnCPU RnENCPU
(Process)
This instruction jumps the program to the FEND or END instruction within the same program file.
Ladder
FBD/LD
Not supported
■Execution condition
Instruction
GOEND
Processing details
• This instruction jumps the program to the FEND or END instruction within the same program file.
Operation error
Error code Description
(SD0)
3340H After execution of the FOR instruction, the GOEND instruction is executed before the NEXT instruction.
3381H After execution of the CALL(P) or ECALL(P) instruction, the GOEND instruction is executed before the RET instruction.
33A1H The GOEND instruction is executed before the IRET instruction in the interrupt program specified by the interrupt pointer (I).
7 APPLICATION INSTRUCTIONS
540
7.2 Program Branch Instructions
RnPCPU RnSFCPU RnSFCPU
(Redundant) (Standard) (Safety)
Execution condition
ST
Not supported